The question is which version has the file you are trying to open? The version of the DWG file you can determine by opening the file in a text editor and looking at the first characters. If the version is greater than "AC1015" than the file format is newer than 2000 and libredwg will probably fail.
Am 23.06.2011 um 21:22 schrieb Davinder Kumar: On 24 June 2011 00:35, R. van Twisk < address@hidden> wrote:
On Jun 23, 2011, at 1:50 PM, Davinder Kumar wrote:
On 23 June 2011 17:03, R. van Twisk <address@hidden> wrote:
On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:
Hello everyone,
I am using libredwg.Whenever i used convert command like
./testSVG input.dwg > output.svg
it gives following error
"Segmentation fault"
David, what version of dwg is that?
If you are talking about version of libredwg, then i don't know the
version of libredwg.I have just installed it through git-clone with
following command
No, the version of the DWG, 2010 versions never worked for me.
You are using which version?
Ries
git clone git://git.sv.gnu.org/libredwg.git
I noticed that DWG version 2010 (I believe)
will always segfault.
Any solution to this.Tell me where i can get the newest version of libredwg.
THis was tested with a draftsight export.
OK.
Ries
--
http://davinder.in
Dont hurt the web, use open standards
--
http://davinder.in
Dont hurt the web, use open standards
-- http://davinder.inDont hurt the web, use open standards
|