Re: [libredwg] Segmentation Fault

[Davinder Kumar]

On 23 June 2011 17:03, R. van Twisk <address@hidden> wrote:
>
> On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:
>
>> Hello everyone,
>> I am using libredwg.Whenever i used convert command like
>> ./testSVG input.dwg > output.svg
>> it gives following error
>> "Segmentation fault"
>
>
> David, what version of dwg is that?
If you are talking about version of libredwg, then i don't know the
version of  libredwg.I have just installed it through git-clone with
following command
git clone git://git.sv.gnu.org/libredwg.git
> I noticed that DWG version 2010 (I believe)
> will always segfault.
Any solution to this.Tell me where i can get the newest version of libredwg.
>
> THis was tested with a draftsight export.
>OK.
> Ries
>
>>
>>
>> --
>> http://davinder.in
>> Dont hurt the web, use open standards
>>
>
>
>



-- 
http://davinder.in
Dont hurt the web, use open standards