Re: [libredwg] Segmentation Fault

[R. van Twisk]

On Jun 23, 2011, at 1:50 PM, Davinder Kumar wrote:

> On 23 June 2011 17:03, R. van Twisk <address@hidden> wrote:
>> 
>> On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:
>> 
>>> Hello everyone,
>>> I am using libredwg.Whenever i used convert command like
>>> ./testSVG input.dwg > output.svg
>>> it gives following error
>>> "Segmentation fault"
>> 
>> 
>> David, what version of dwg is that?
> If you are talking about version of libredwg, then i don't know the
> version of  libredwg.I have just installed it through git-clone with
> following command

No, the version of the DWG, 2010 versions never worked for me.

Ries

> git clone git://git.sv.gnu.org/libredwg.git
>> I noticed that DWG version 2010 (I believe)
>> will always segfault.
> Any solution to this.Tell me where i can get the newest version of libredwg.
>> 
>> THis was tested with a draftsight export.
>> OK.
>> Ries
>> 
>>> 
>>> 
>>> --
>>> http://davinder.in
>>> Dont hurt the web, use open standards
>>> 
>> 
>> 
>> 
> 
> 
> 
> -- 
> http://davinder.in
> Dont hurt the web, use open standards
>