[Lynx-dev] https Again?

[Chime Hart]

Well, just like back in July, this whole ssl thing has bit me again. After 
reading Jude-and-Tomas replies, I ran their options, but then I noticed when 
running
which lynx
on consoles which were run after a "rehash" says /usr/local/bin/lynx. Meanwhile 
other consoles here in TCSH Debian Sid say /usr/bin/lynx So when running lynx 
from a command-prompt, I not only receive an ssl error, but my externals are 
not working. However, as alpine calls lynx from /usr/bin/lynx    should I just 
run
sudo cp /usr/local/bin/lynx /usr/bin/lynx
As an opinion, I would think an install should respect if ssl was already 
working. Thanks so much in advance
Chime