Re: [Mtools] Reading label from a large capacity memory card

[Simon Large]

Alain Knaff wrote:
> Simon Large wrote:
>>> dd if=/dev/sda1 bs=512 count=1 of=bootsector.bin
>>> 
>>> Replace /dev/sda1 as appropriate. (/dev/sdb3 for third partition on
>>> second SCSI-like device, etc.)
>> 
>> Here are the boot sectors for 2 cards that I tried.
>> The 2GB card works OK and reports "Volume label is SIMON TEST".
>> The 8GB card reports "Big disks not supported on this architecture".
>> 
>> Using 3.9.11
>> 
>> Simon
> 
> I tried it here (mtools-3.9.11-5.fc10.i386), and got no maxsize
> problem (I did get a different error about the FAT, but that's
> because I've only the boot sector).  
> 
> Just to make sure, if you don't mind, could you send me the 15000
> first sectors (count=15000) of that disk, that should be enough for a
> successful mlabel on my side.  

Attached.

Sounds like it maybe a config problem on my side. I'm compiling for
arm-linux here to run on an embedded Atmel ARM9 device.

Simon

sector15k.zip
Description: sector15k.zip